Netgear XCM8810 Chassis Hardware Installation Guide - Page 765
con stpd ports priority, A setting of 0 indicates the highest priority.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 765 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default The default is 128. Usage Guidelines If your STPD has the same name as another component, for example a VLAN, NETGEAR recommends that you specify the identifying keyword as well as the name. If your STPD has a name unique only to that STPD, the keyword stpd is optional. You should not configure any STP parameters unless you have considerable knowledge and experience with STP. The default STP parameters are adequate for most networks. By changing the priority of the port, you can make it more or less likely to become the root port or a designated port. A setting of 0 indicates the highest priority. The range for the priority parameter is 0 through 240 and is subject to the multiple of 16 restriction. Example The following command assigns a priority of 32 to slot 2, ports 1 through 5 in STPD s0: configure stpd s0 ports port-priority 32 2:1-2:5 configure stpd ports priority configure stpd ports priority Description Specifies the port priority of the port in the specified STPD. Syntax Description stpd_name priority port_list Specifies an STPD name on the switch. Specifies a numerical port priority value. The range is 0 through 31 for STP and 0 through 15 for MSTP and RSTP. Specifies one or more ports or slots and ports. Default The default is 128. Usage Guidelines If your STPD has the same name as another component, for example a VLAN, NETGEAR recommends that you specify the identifying keyword as well as the name. If your STPD has a name unique only to that STPD, the keyword stpd is optional. Chapter 17. STP Commands | 765