Netgear XCM8810 Chassis Hardware Installation Guide - Page 1018
con ospf vlan timer
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1018 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command deletes the IP address of a point-to-point neighbor: configure ospf vlan accounting neighbor delete 10.0.0.1 configure ospf vlan timer configure ospf vlan [ | all] timer {} Description Configures the OSPF wait interval for a VLAN or all VLANs. Syntax Description vlan-name retransmit-interval transit-delay hello-interval dead-interval wait-timer-interval Specifies a VLAN name. Specifies the length of time that the router waits before retransmitting an LSA that is not acknowledged. The range is 1 - 3,600. Specifies the length of time it takes to transmit an LSA packet over the interface. The range is 0 - 3,600 seconds. Specifies the interval at which routers send hello packets. The range is 1 - 65,535 seconds. Specifies the interval after which a neighboring router is declared down due to the fact that hello packets are no longer received from the neighbor. The range is 1 2,147,483,647. Specifies the interval between the interface coming up and the election of the DR and BDR. Usually equal to the dead timer interval. Default • retransmit interval-5 seconds. • transit delay-1 second. • hello interval-10 seconds. • dead interval-40 seconds. • wait timer interval-dead interval. Usage Guidelines Specify the following: • retransmit interval-If you set an interval that is too short, unnecessary retransmissions will result. • transit delay-The transit delay must be greater than 0. 1018 | Chapter 23. OSPF Commands