Netgear XCM8810 Chassis Hardware Installation Guide - Page 1016
con ospf vlan area
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1016 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines Configuring OSPF timers on a per-area basis is a shorthand for applying the timers and authentication to each VLAN in the area at the time of configuration. If you add more VLANs to the area, you must configure the timers and authentication for the new VLANs explicitly. Example The following command sets the timers on the virtual link in area 0.0.0.2 and remote router ID 6.6.6.6: configure ospf virtual-link 6.6.6.6 0.0.0.2 timer 10 1 20 200 configure ospf vlan area configure ospf vlan area Description Associates a VLAN (router interface) with an OSPF area. By default, all router interfaces are associated with area 0.0.0.0. Syntax Description vlan-name area-identifier Specifies a VLAN name. Specifies an OSPF area. Default Area 0.0.0.0 Usage Guidelines Any OSPF network that contains more than one area is required to have an area configured as area 0, also called the backbone. All areas in an autonomous system must be connected to the backbone. When designing networks, you should start with area 0, and then expand into other areas. The backbone allows summary information to be exchanged between ABRs. Every ABR hears the area summaries from all other ABRs. The ABR then forms a picture of the distance to all networks outside of its area by examining the collected advertisements, and adding in the backbone distance to each advertising router. When a VLAN is configured to run OSPF, by default you must assign it to an area. Example The following command associates the VLAN accounting with an OSPF area: configure ospf vlan accounting area 0.0.0.6 1016 | Chapter 23. OSPF Commands