Netgear XCM8810 Chassis Hardware Installation Guide - Page 579

NETGEAR 8800 Chassis Switch CLI Manual The netlogin keyword specifies the RADIUS server used for network login authentication. If you do not specify the mgmt-access or netlogin keywords, the timeout interval applies to both switch management and netlogin RADIUS servers. Example The following command configures the timeout interval for RADIUS authentication to 10 seconds. After 30 seconds (three attempts), the alternate RADIUS server will be used. After 60 seconds (six attempts) local user authentication is used. configure radius timeout 10 configure radius-accounting server client-ip configure radius-accounting {mgmt-access | netlogin} [primary | secondary] server [ | ] {} client-ip [] {vr } Description Configures the RADIUS accounting server. Syntax Description mgmt-access netlogin primary secondary ipaddress hostname tcp_port ipaddress vr_name Specifies the RADIUS accounting server for switch management. Specifies the RADIUS accounting server for network login. Configure the primary RADIUS accounting server. Configure the secondary RADIUS accounting server. The IP address of the accounting server being configured. The host name of the accounting server being configured. The UDP port to use to contact the RADIUS accounting server. The IP address used by the switch to identify itself when communicating with the RADIUS accounting server. Specifies the virtual router on which the client IP is located. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. Default The following lists the default behavior of this command: • The UDP port setting is 1813 • The virtual router used is VR-Mgmt, the management virtual router • Switch management and network login use the same RADIUS accounting server. Chapter 15. Security Commands | 579