Netgear XCM8810 Chassis Hardware Installation Guide - Page 540
enable diffserv examination ports, enable diffserv replacement ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 540 highlights
NETGEAR 8800 Chassis Switch CLI Manual Note: The specified ports are ingress ports. Example The following command disables 802.1p value replacement on all ports: disable dot1p replacement ports all enable diffserv examination ports enable diffserv examination ports [ | all] Description Enables the DiffServ field of an IP packet to be examined in order to select a QoS profile. Syntax Description port_list all Specifies a list of ports or slots and ports to which the parameters apply. Specifies that DiffServ examination is enabled for all ports. Default Disabled. Usage Guidelines The Diffserv examination feature is disabled by default. If you are using DiffServ for QoS parameters, NETGEAR recommends that you also configure 802.1p or port-based QoS parameters to ensure that high-priority traffic is not dropped prior to reaching the MSM/MM on the switch. Example The following command enables DiffServ examination on selected ports: enable diffserv examination ports 1:1,5:5,6:2 enable diffserv replacement ports enable diffserv replacement ports [ | all] Description Enables the DiffServ code point to be overwritten in IP packets transmitted by the switch. 540 | Chapter 14. QoS Commands