Netgear XCM8810 Chassis Hardware Installation Guide - Page 1082
con bgp delete aggregate-address, routing confederation, RFC 5396
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1082 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Specifies a BGP routing confederation ID. Syntax Description confederation-id Specifies a routing confederation identifier, which is a 4-byte AS number in the range of 1 to 4294967295. Default N/A. Usage Guidelines IBGP requires that networks use a fully-meshed router configuration. This requirement does not scale well, especially when BGP is used as an interior gateway protocol. One way to reduce the size of a fully-meshed AS is to divide the AS into multiple sub-autonomous systems and group them into a routing confederation. Within the confederation, each sub-AS must be fully-meshed. The confederation is advertised to other networks as a single AS. Use a confederation ID of 0 to indicate no confederation. The confederation ID is a 4-byte AS number in either the ASPLAIN or the ASDOT format as described in RFC 5396, Textual Representation of Autonomous System (AS) Numbers. Example The following command specifies a BGP routing confederation ID using the ASPLAIN 4-byte AS number format: configure bgp confederation-id 1000000 The following command specifies a BGP routing confederation ID using the ASDOT 4-byte AS number format: configure bgp confederation-id 15.16960 configure bgp delete aggregate-address configure bgp delete aggregate-address {address-family [ipv4-unicast | ipv4-multicast]} [ | all] Description Deletes one or all BGP aggregated route. Syntax Description address-family The address family. BGP supports two address families: IPv4 unicast and IPv4 multicast. 1082 | Chapter 25. BGP Commands