Netgear XCM8810 Chassis Hardware Installation Guide - Page 528

NETGEAR 8800 Chassis Switch CLI Manual Syntax Description qosprofile committed_rate maxbw minbw peak_rate percent use-strict-priority value Specifies a QoS profile name. Range is QP1 to QP8; the defaults are QP1 and QP8. Specifies a committed information rate in Kbps (k) bits or Mbps (m). The maximum bandwidth (maxbw) option specifies the peak rate as a percentage of the maximum port speed. The range is 0 to 100%, and the default value is 100. When autonegotiation is off, the peak rate is the specified percentage of the configured port speed. When autonegotiation is on, the peak rate is the specified percentage of the maximum port speed (the switch does not detect the negotiated port speed). The minimum bandwidth (minbw) option specifies the committed information rate as a percentage of the maximum port speed. The range is 0 to 100%, and the default value is 0. When autonegotiation is off, the CIR is the specified percentage of the configured port speed. When autonegotiation is on, the CIR is the specified percentage of the maximum port speed. Specifies a peak rate in Kbps (k) bits or Mbps (m). Specifies the percentage of the total buffer you are reserving for this QoS profile. The range is 1 to 100; the default setting is 100. When the global qosscheduler configuration (configure qosscheduler command) is set to weighted-round-robin, this option overrides the global configuration for the specified QoS profile, so that it operates in strict-priority-mode. This enables hybrid strict-priority and weighted-round-robin scheduling operation. Specifies the weight value used for queue service weighting in the weighted-round-robin scheduler for this QoS profile. The range is 1 to 16; default is 1. Default • QoS profiles-QP1 through QP8 on NETGEAR 8800 series switches. • Minimum bandwidth-0% • Maximum bandwidth-100% • Maximum buffer-100% • Weight-1 Usage Guidelines On NETGEAR 8800 series switches, QoS profiles QP1 through QP8 are preconfigured and cannot be deleted. The maxbuffer parameter configures the maximum amount of packet buffer, by percentage, that the packets associated with the specified QoS profile can consume. Regardless of the setting for this parameter, the system does not drop any packets as long as packet buffer memory remains available and the current buffer use of the specified QoS profile is below the specified maxbuffer setting. 528 | Chapter 14. QoS Commands