Netgear XCM8810 Chassis Hardware Installation Guide - Page 421
uncon sflow collector
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 421 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command resets the agent IP back to the management IP address: unconfigure sflow agent unconfigure sflow collector unconfigure sflow collector {ipaddress} {port } {vr } Description Unconfigures the sFlow collector. Syntax Description ip-address Specifies the IP address of the collector to reset. udp-port-number Specifies the UDP port. vrname Specifies which virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. Default The following values are the defaults for this command: • UDP port number-6343 • Virtual router-VR-Mgmt (previously called VR-0). Usage Guidelines This command allows you to reset the specified sFlow collector parameters to the default values. The unconfigure sflow collector command will reset the collector parameters to the default. Example The following command removes the collector at IP address 192.168.57.1: unconfigure sflow collector ipaddress 192.168.57.1 unconfigure sflow ports unconfigure sflow ports Description Removes the specified ports from the sFlow configuration, and stops sampling them. Chapter 8. Commands for Status Monitoring and Statistics | 421