Netgear XCM8810 Chassis Hardware Installation Guide - Page 254
The following command displays detailed port system-related information on the NETGEAR, switch
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
NETGEAR 8800 Chassis Switch CLI Manual The following command displays detailed port system-related information on the NETGEAR 8800 switch: show ports 3:1 information detail Following is sample output from this command: Port: 3:1 Virtual-router: VR-Default Type: UTP Random Early drop: Unsupported Admin state: Enabled with auto-speed sensing (100M Advertised), auto-duplex (half-duplex Advertised) ELSM Link State: Up Link State: Active, 1 Gbps, full-duplex Link Counter: Up 1 time(s) VLAN cfg: Name: Default, Internal Tag = 1 (MAC-Based), MAC-limit = No-limit STP cfg: s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING Protocol: Name: Default Protocol: ANY Match all protocols. Trunking: Load sharing is not enabled. ELSM: Enabled Learning: Enabled Unicast Flooding: Enabled Multicast Flooding: Enabled Broadcast Flooding: Enabled Jumbo: Enabled, MTU= 9194 Flow Control: Rx-Pause: Disabled Tx-Pause: Disabled Link up/down SNMP trap filter setting: Enabled Egress Port Rate: 128 Kbps, Max Burst Size: 200 Kb Broadcast Rate: No-limit Multicast Rate: No-limit Unknown Dest Mac Rate: No-limit QoS Profile: QP3 configured by user Ingress Rate Shaping : Unsupported Ingress IPTOS Examination: Disabled Ingress 802.1p Examination: Enabled Ingress 802.1p Inner Exam: Disabled Egress IPTOS Replacement: Disabled Egress 802.1p Replacement: Disabled NetLogin: Enabled NetLogin authentication mode: MAC based NetLogin port mode: MAC based VLANs Smart redundancy: Enabled 254 | Chapter 5. Commands for Configuring Slots and Ports on a Switch