Netgear XCM8810 Chassis Hardware Installation Guide - Page 880
The following command displays the IP ARP table for the current virtual router
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 880 highlights
NETGEAR 8800 Chassis Switch CLI Manual Pending entries In Request In Response Out Request Out Response Failed requests Proxy Answered RX Error Dup IP Addr Rejected Count Rejected IP Rejected Port Rejected I/F Max ARP entries Max ARP pending entries ARP address check ARP refresh Timeout The number of sent ARP requests that have not yet received a response. The number of ARP request packets received (by this virtual router). The number of ARP reply packets received (by this virtual router). The number of ARP request packets sent (by this virtual router). The number of ARP reply packets sent (by this virtual router). The number of failed ARP requests sent (by this virtual router). The number of ARP requests answered by the ARP proxy. The number of incorrect ARP request and reply packets received. The malformed packets include the following errors: incorrect ARP op code, hardware address type is not Ethernet, the protocol address is not IP, and similar errors. IP addresses that have been used by other hosts on the network. The number of rejected ARP request packets. The source address for the last rejected ARP request. An example reason for an ARP request packet to be rejected is if the source address of the packet is not in the subnet. The port on which the last rejected ARP request packet arrived. The VLAN on which the last rejected ARP request packet arrived. Maximum ARP table size for the virtual router (each virtual router has its own ARP table). Maximum number of incomplete (pending) ARP entries allowed in the table. Whether IP ARP checking is enabled or disabled. IP ARP checking verifies if the ARP request's source address is in the receiving interface's subnet. Whether ARP refresh is enabled or disabled. ARP refresh is performed when an ARP entry's age is three-fourths of the timeout value. Timeout value for a dynamic (learned) ARP entry. Example The following command displays the IP ARP table for the current virtual router: show iparp The following is sample output for the command: VR VR-Default VR-Default VR-Default VR-Default VR-Default VR-Default Destination 10.10.10.6 10.128.32.1 10.128.32.2 10.128.32.4 10.128.32.5 10.128.32.6 Mac Age Static VLAN 00:04:96:1f:a5:71 8 NO bluered 00:01:30:ba:6a:a0 0 NO Default 00:01:03:1c:ae:b0 5 NO Default 00:d0:59:17:74:83 3 NO Default 00:02:a5:c2:5c:dd 0 NO Default 00:12:3f:1c:f8:fb 5 NO Default VID Port 4092 1 4095 4095 4095 4095 4095 880 | Chapter 19. IP Unicast Commands