Netgear XCM8810 Chassis Hardware Installation Guide - Page 429
con vlan add ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 429 highlights
NETGEAR 8800 Chassis Switch CLI Manual • llc - LLC Service Advertising Protocol. • snap - Ethertype inside an IEEE SNAP packet encapsulation. Example The following command deletes protocol type LLC SAP with a value of FEFF from protocol fred: configure protocol fred delete llc feff configure vlan add ports configure {vlan} add ports [ | all] {tagged | untagged} {{stpd} } {dot1d | emistp | pvst-plus}} Description Adds one or more ports in a VLAN. Syntax Description vlan_name port_list all tagged untagged stpd_name dot1d | emistp | pvst-plus Specifies a VLAN name. Specifies a list of ports or slots and ports. Specifies all ports. Specifies the ports should be configured as tagged. Specifies the ports should be configured as untagged. Specifies an STP domain name. Specifies the BPDU encapsulation mode for these STP ports. Default Untagged. Usage Guidelines The VLAN must already exist before you can add (or delete) ports: use the create vlan command to create the VLAN. If the VLAN uses 802.1Q tagging, you can specify tagged or untagged port(s). If the VLAN is untagged, the ports cannot be tagged. Untagged ports can only be a member of a single VLAN. By default, they are members of the default VLAN (named Default). In order to add untagged ports to a different VLAN, you must first remove them from the default VLAN. You do not need to do this to add them to another VLAN as tagged ports. if you attempt to add an untagged port to a VLAN prior to removing it from the default VLAN, you see the following error message: Chapter 9. VLAN Commands | 429