Netgear XCM8810 Chassis Hardware Installation Guide - Page 303
con inline-power label ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 303 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Configures the disconnect precedence priority for the switch when a new PD is detected and the measured inline power for that switch or specified slot is within 19 W of the switch's or slot's PoE power budget. Syntax Description deny-port lowest-priority Specifies power be denied to PD requesting power, regardless of priority. Specifies power be withdrawn from lowest-priority port(s) when next PD requesting power connects. Default Deny-port. Usage Guidelines You configure this parameter for the switch; you cannot configure this per slot or per port. If the power supplied to the PDs on a switch or specified slot exceeds the power that was budgeted for that switch or specified slot, the system disconnects power to one or more ports to prevent power overload. Refer to configure inline-power budget for information on configuring and modifying the power budgeted for each switch or specified slot. You configure the switch to either deny power to the next PD that requests power on that switch or slot, regardless of the priority, or to disconnect those PDs on ports with lower priorities until there is enough power for the new PD. If you select this last argument and you did not configure port priorities or if several ports have the same priority, the switch withdraws power (or disconnects) those ports with the highest port number (s). Refer to configure inline-power priority ports for information on configuring the PoE priority for the ports. The default value is deny-port. So, if you do not change the default value and the switch's or slot's power is exceeded, the next PD requesting power will not be connected. When the setting is lowest priority, the switch continues dropping ports with the lowest configured PoE port priorities, or the highest port number in the case of equal PoE port priorities, until there is enough power for the requesting PD. Example The following command sets the switch to withdraw power from the lowest-priority port(s): configure inline-power disconnect-precedence lowest-priority configure inline-power label ports configure inline-power label ports Chapter 7. PoE Commands | 303