Netgear XCM8810 Chassis Hardware Installation Guide - Page 1148
enable bgp peer-group capability
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1148 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines You can use BGP peer groups to group together up to 200 BGP neighbors. All neighbors within the peer group inherit the parameters of the BGP peer group. The following mandatory parameters are shared by all neighbors in a peer group: • remote AS • source-interface • out-nlri-filter • out-aspath-filter • out-route-map • send-community • next-hop-self Example The following command enables the BGP peer group outer and all its neighbors: enable bgp peer-group outer enable bgp peer-group capability enable bgp peer-group capability [ipv4-unicast | ipv4-multicast | route-refresh] Description This command enables BGP Multiprotocol (MP) and route-refresh capabilities for a peer-group. Syntax Description peer-group-name ipv4-unicast ipv4-multicast route-refresh Specifies a peer group. Specifies BGP MP unicast capabilities. Specifies BGP MP multicast capabilities. Specifies ROUTE-REFRESH message capabilities. Default All capabilities are disabled by default. 1148 | Chapter 25. BGP Commands