Netgear XCM8810 Chassis Hardware Installation Guide - Page 541
enable dot1p examination ports, explicit packet class of service information and physical/logical
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 541 highlights
NETGEAR 8800 Chassis Switch CLI Manual Syntax Description port_list all Specifies a list of ingress ports or slots and ports on which to enable Diffserv replacement. Specifies that DiffServ replacement should be enabled for all ports. Default N/A. Usage Guidelines The Diffserv replacement feature is disabled by default. Note: The port in this command is the ingress port. This command affects only that traffic in traffic groupings based on explicit packet class of service information and physical/logical configuration. Example The following command enables DiffServ replacement on specified ports: enable diffserv replacement ports 5:3,5:5,6:2 enable dot1p examination ports enable dot1p examination ports [ | all] Description Enables egress QoS profile selection based on the 802.1p bits in the incoming frame. Syntax Description port_list all Specifies a list of ports on which to enable the dot1p examination feature. Specifies that dot1p examination should be enabled for all ports. Default Enabled. Chapter 14. QoS Commands | 541