Netgear XCM8810 Chassis Hardware Installation Guide - Page 92
con sntp-client, will be generated using the MAC address of the MSM/MM
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Configures the SNMPv3 snmpEngineID. Syntax Description hex_engine_id Specifies the colon delimited hex octet that serves as part of the snmpEngineID (5-32 octets). Default The default snmpEngineID is the device MAC address. Usage Guidelines Use this command if the snmpEngineID needs to be explicitly configured. The first four octets of the ID are fixed to 80:00:11:AE,which represents the NETGEAR Vendor ID. Once the snmpEngineID is changed, default users will be reverted back to their original passwords/keys, while non-default users will be reset to the security level of no authorization, no privacy. In a chassis, the snmpEngineID will be generated using the MAC address of the MSM/MM with which the switch boots first. For MSM/MM hitless failover, the same snmpEngineID will be propagated to both of the MSMs/MMs. Example The following command configures the snmpEngineID to be 80:00:11:AE:00:0a:1c:3e:11: configure snmpv3 engine-id 00:0a:1c:3e:11 configure sntp-client configure sntp-client [primary | secondary] {vr } Description Configures an NTP server for the switch to obtain time information. Syntax Description primary secondary host-name-or-ip vr Specifies a primary server name. Specifies a secondary server name. Specifies a host name or IPv4 address or IPv6 address. Specifies use of a virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A of the NETGEAR 8800 User Manual. 92 | Chapter 3. Commands for Managing the Switch