Netgear XCM8810 Chassis Hardware Installation Guide - Page 251
show ports information, Following is sample output from this command
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command displays the port configuration for all ports: show ports configuration Port Configuration Monitor Fri Apr 13 10:22:29 2007 Port Virtual Port Link Auto Speed Duplex Flow Load Media router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red 1 VR-Default E R ON AUTO AUTO NONE UTP 2 VR-Default E R ON AUTO AUTO NONE UTP 3 VR-Default E R ON AUTO AUTO NONE UTP 4 VR-Default E R ON AUTO AUTO NONE UTP 5 VR-Default E R ON AUTO AUTO NONE 6 VR-Default E R ON AUTO AUTO NONE 7 VR-Default E R OFF 100 FULL SX 8 VR-Default E R ON AUTO AUTO NONE 9 VR-Default E R ON AUTO AUTO NONE 10 VR-Default E R ON AUTO AUTO NONE 11 VR-Default E R ON AUTO AUTO NONE 12 VR-Default E R ON AUTO AUTO NONE 13 VR-Default E R ON AUTO AUTO NONE 14 VR-Default E R ON AUTO AUTO NONE 15 VR-Default E R ON AUTO AUTO NONE Link State: A-Active, R-Ready, NP-Port Not Present, L-Loopback Port State: D-Disabled, E-Enabled, Media: !-Unsupported Optic Module Media Red: * - use "show port info detail" for redundant media type 0->Clear Counters U->page up D->page down ESC->exit The following command displays the port configuration statistics for slot 2, port 2: show ports 2:2 configuration Following is sample output from this command: Port Configuration Port Virtual Port Link Auto Speed Duplex Flow Load Media router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red 2:2 VR-Default E R ON AUTO AUTO UTP Link State: A-Active, R-Ready, NP-Port not present, L-Loopback Port State: D-Disabled E-Enabled, Media: !-Unsupported Optic Module 0->Clear Counters U->page up D->page down ESC->exit show ports information show ports {mgmt | } information {detail} Chapter 5. Commands for Configuring Slots and Ports on a Switch | 251