Netgear XCM8810 Chassis Hardware Installation Guide - Page 1163
IP Multicast Commands
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1163 highlights
26. IP Multicast Commands 26 This chapter describes commands for configuring and managing the following IPv4 multicast features: • Multicast routing • Protocol Independent Multicast (PIM) • Internet Group Management Protocol (IGMP) • Multicast VLAN Registration (MVR) For an introduction to these features, see the NETGEAR 8800 User Manual. clear igmp group clear igmp group {} {{vlan} } Description Removes one or all IGMP groups. Syntax Description name grpipaddress Specifies a VLAN name. Specifies the group IP address. Default N/A. Usage Guidelines This command can be used by network operations to manually remove learned IGMP group entries instantly. Traffic is impacted until the IGMP groups are relearned. Use this command for diagnostic purposes only. Example The following command clears all IGMP groups from VLAN accounting: Chapter 26. IP Multicast Commands | 1163