Netgear XCM8810 Chassis Hardware Installation Guide - Page 487
ACL Commands
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 487 highlights
13. ACL Commands 13 This chapter describes commands for creating and configuring IP access lists (ACLs). IP access lists (also referred to as Access Lists or ACLs) consist of IP access rules and are used to perform packet filtering and forwarding decisions on traffic traversing the switch. Each packet on an interface is compared to the access list in sequential order and is either forwarded to a specified QoS profile or dropped. Additionally, for the NETGEAR 8800 series switches, packets can be metered using ACLs. Using access lists has no impact on switch performance. Access lists are typically applied to traffic that crosses Layer 3 router boundaries, but it is possible to use access lists within a Layer 2 VLAN. NETGEAR products are capable of performing this function with no additional configuration. Note: Although the NETGEAR 8800 does not prohibit mixing ACL and routing type entries in a policy file, it is strongly recommended that you do not mix the entries, and you use separate policy files for ACL and routing policies. clear access-list counter clear access-list {dynamic} counter {} {any | ports | vlan } {ingress | egress} Description Clears the specified access list counters. Syntax Description dynamic countername any portlist vlanname Specifies that the counter is from a dynamic ACL. Specifies the ACL counter to clear. Specifies the wildcard ACL. Specifies to clear the counters on these ports. Specifies to clear the counters on the VLAN. Chapter 13. ACL Commands | 487