Netgear XCM8810 Chassis Hardware Installation Guide - Page 527
con qosprofile
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 527 highlights
NETGEAR 8800 Chassis Switch CLI Manual Syntax Description port_list no-limit cir-rate max-burst-size Specifies one or more ports or slots and ports. Specifies traffic be transmitted without limit; use to reconfigure or unconfigure previous rate-limiting parameters. Specifies the desired rate limit in Kbps, Mbps, or Gbps. Specifies the maximum burst size or peak burst size in kilobits (Kb) or megabits (Mb). Default No-limit. Usage Guidelines Port speed limits the egress traffic, as follows: • 1 Gbps port-64 Kbps increments • 10 Gbps port-1 Mbps increments If the specified egress limit (cir-rate) is not a multiple of 64 Kbps for a 1 Gbps port or 1 Mbps for a 10 Gbps port, the specified value is rounded down to the nearest appropriate multiple based on the port type. Use the no-limit parameter to: • Unconfigure egress rate limiting on the port(s) • Reconfigure existing egress rate limiting on the port(s) The max-burst-size parameter is the amount of traffic above the value in the cir-rate parameter that is allowed to burst from the port(s) for a short duration. Example The following command configures egress rate-limiting on slot 3 port 1 of the switch for 3 Mbps and a maximum burst size or 5 M bits: configure port 3:1 rate-limit egress 3 Mbps max-burst-size 5 Mb configure qosprofile configure qosprofile {committed_rate [k | m]} {maxbuffer } {maxbw } {minbw } {peak_rate [k | m]} {use-strict-priority} {weight } Description Modifies the rate-shaping parameters for QoS profiles on NETGEAR 8800 switches. Chapter 14. QoS Commands | 527