Netgear XCM8810 Chassis Hardware Installation Guide - Page 285
For additional information on power support, see
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Configures the LLDP port to advertise or not advertise MED power requirement details. This TLV can only be enabled on a PoE-capable port and is used for advanced power management between the MED network connectivity and endpoint devices. Syntax Description all port_list advertise no-advertise Specifies all ports on the switch. Specifies one or more ports or slots and ports. Specifies to send the information to neighbors. Specifies not to send the information to neighbors. Default No advertise. Usage Guidelines When enabled, this LLDP MED TLV advertises fine-grained power requirement details about PoE settings and support. This TLV can be enabled only on a PoE-capable port; the switch returns an error message if this TLV is configured for a non-PoE-capable port. You must configure the LLDP MED capabilities TLV before configuring this TLV. Configure the LLDP MED capabilities TLV using the configure lldp ports [all | ] [advertise | no-advertise] vendor-specific med capabilities command. As with all the LLDP MED TLVs, the switch sends this TLV only after it detects a MED-capable device on the port. The switch does not automatically send this TLV after it is enabled; the switch must first detect a MED-capable device on the port. Note: For additional information on power support, see the configure lldp ports vendor-specific dot3 power-via-mdi command. The following information is transmitted for LLDP MED PoE-capable ports with this TLV: • Power type Set to PSE. • Power source Set to primary power source. • Power priority Taken from PoE port configuration. • Power value Chapter 6. Commands for Configuring LLDP | 285