Netgear XCM8810 Chassis Hardware Installation Guide - Page 477

NETGEAR 8800 Chassis Switch CLI Manual Description Displays information about the virtual routers. Syntax Description vr-name Specifies the name of the virtual router. Default N/A. Usage Guidelines During system boot up, the NETGEAR 8800 creates three system virtual routers: VR-Mgmt, VR-Control, and VR-Default (previous to release 11.0 these virtual routers were named VR-0, VR-1, and VR-2, respectively). The following defines each system virtual router: • The management port on both the primary and backup MSMs/MMs and the VLAN mgmt belong to VR-Mgmt. • Internal system operations use VR-Control. • The default VLAN belongs to VR-Default. Beginning with release 11.0, you can create additional virtual routers, called user virtual routers. User virtual routers are created without any routing protocols, so the protocols must be added. The protocols on the system virtual routers are predefined and cannot be changed. The output displays, in tabular format, the: • Name of the virtual router • Number of VLANs that belong to that virtual router • Number of ports that belong to that virtual router • Which routing protocols have been added to that virtual router When you specify a particular virtual router, the output displays: • The number of ports • A list of ports • The protocols configured • The name of the process supporting the protocol on that virtual router Examples The following command displays the virtual router configurations on the switch: Switch.19 # show virtual-router Virtual Router Number of Number of Flags Chapter 11. Commands for Virtual Routers | 477