Netgear XCM8810 Chassis Hardware Installation Guide - Page 497
con flow-redirect nexthop, candidate is selected from the remaining active nexthops.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 497 highlights
NETGEAR 8800 Chassis Switch CLI Manual configure flow-redirect flow10 health-check arp configure flow-redirect nexthop configure flow-redirect nexthop ping interval miss Description Configures the ping interval and miss count for a nexthop in the flow redirection policy. Syntax Description flow-redirect-name ip address interval miss Specifies the name of the flow redirection policy. Specifies the IP address of the nexthop Specifies the number of seconds between pings. The default is "2". Specifies the number of misses allowed. The default is "2". Default N/A. Usage Guidelines Use this command to set a ping interval and miss count. When the ping response is not received with the interval * (miss +1), the nexthop is considered to be dead and a new candidate is selected from the remaining active nexthops. Example The following command configures a ping interval of 3 and miss count of 3 for the nexthop 10.1.1.1 in the flow redirection policy flow 3: configure flow-redirect flow3 nexthop 10.1.1.1 ping interval 3 miss 3 configure flow-redirect no-active configure flow-redirect no-active [drop|forward] Description Configures packets to either follow the normal routing table or be dropped. Syntax Description flow-redirect-name drop Specifies the name of the flow redirection policy. Specifies that the packets are to be dropped. Chapter 13. ACL Commands | 497