Netgear XCM8810 Chassis Hardware Installation Guide - Page 978

NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines Use the in option to configure an input route policy, which determines which RIPng routes are accepted as valid routes from RIPng neighbors. This policy can be combined with the trusted neighbor policy to accept selected routes only from a set of trusted neighbors. Use the out option to configure an output route policy, which determines which RIPng routes are advertised to other RIPng neighbors. The following is a sample policy file that could be used with RIPng. It will drop any routes from the subnets 2001:db8:2ccc::/64 and 2001:db8:2ccd::/64: entry filter_routes { If match any{ nlri 2001:db8:2ccc:: /64; nlri 2001:db8:2ccd:: /64; } then { deny; } } Example The following command configures the VLAN backbone to accept routes from its neighbor as specified by the policy nosales: configure ripng vlan backbone route-policy in nosales The following command uses the policy nosales to determine which RIP routes are advertised into the VLAN backbone: configure rip vlan backbone route-policy out nosales configure ripng routetimeout configure ripng routetimeout Description Configures the route timeout period for RIPng. Syntax Description seconds Specifies a time in seconds. Range is 10 to 3600. 978 | Chapter 22. RIPng Commands