Netgear XCM8810 Chassis Hardware Installation Guide - Page 112
show checkpoint-data, backup MSM/MM.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command logs out the session of a current user for CLI or Telnet: quit A message similar to the following is displayed: Do you wish to save your configuration changes to primary.cfg? (y or n) Enter y if you want to save your changes. Enter n if you do not want to save your changes. show checkpoint-data show checkpoint-data {} Description Displays the status of one or more processes being copied from the primary MSM/MM to the backup MSM/MM. Syntax Description process Specifies the name of the processes being copied. Default N/A. Usage Guidelines This command displays, in percentages, the amount of internal state copying completed by each process and the traffic statistics between the process on both the primary and the backup MSMs/MMs. This command is also helpful in debugging synchronization problems that occur at run-time. To check the status of synchronizing the MSMs/MMs, use the show switch command. Depending on the software version running on your switch and the type of switch you have, additional or different checkpoint status information may be displayed. Example The following command displays the checkpointing status and the traffic statics of all of the processes between the primary and the backup MSM: show checkpoint-data The following is sample output from this command: Process Tx Rx Errors Sent Total % Chkpt Debug-info devmgr 3812 1731 0 3 3 100% ON OK 1 (00008853) 112 | Chapter 3. Commands for Managing the Switch