Netgear XCM8810 Chassis Hardware Installation Guide - Page 1188
con pim cbsr, The following command enables PIM-DM multicast routing on VLAN
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1188 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default Dense. Usage Guidelines When an IP interface is created, per-interface PIM configuration is disabled by default. The switch supports both dense mode and sparse mode operation. You can configure dense mode or sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while others run sparse mode. Passive interfaces are host only interfaces that allow a multicast stream from other VLANs to be forwarded to edge hosts. Since they do not peer with other PIM routers, do not connect a multicast router to a passive interface. In order for the interface to participate in PIM, PIM must be enabled on the switch using the following command: enable pim Example The following command enables PIM-DM multicast routing on VLAN accounting: configure pim add vlan accounting dense configure pim cbsr configure pim cbsr [{vlan} {