Netgear XCM8810 Chassis Hardware Installation Guide - Page 974
con ripng add, RIPng Commands, NETGEAR 8800 Chassis Switch CLI Manual
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 974 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines None. Example The following command clears the RIPng statistics counters: clear ripng counters configure ripng add configure ripng add [vlan | tunnel | [vlan | tunnel] all] Description Configures RIPng on an IP interface. Syntax Description vlan-name tunnel-name all Specifies an IPv6 configured VLAN. Specifies an IPv6 tunnel. Specifies all IPv6 configured VLANs or tunnels. Default N/A. Usage Guidelines For RIPng to be active on the interface, it must also be globally enabled using the command enable ripng. If the keyword all is specified, all IPv6 configured VLANs or tunnels will be configured for RIPng. Example The following command configures RIPng on the VLAN finance: configure ripng add finance configure ripng cost configure ripng [vlan | tunnel ] cost 974 | Chapter 22. RIPng Commands