Netgear XCM8810 Chassis Hardware Installation Guide - Page 1117
con bgp restart address-family
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1117 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default The default is none; graceful restart is disabled. Usage Guidelines This command configures the router as a graceful BGP router. You can decide to configure a router to enter graceful restart for only planned restarts, for only unplanned restarts, or for both. Also, you can decide to configure a router to be a receiver only (which helps a restarting BGP router to perform the graceful restart process), and not to do graceful restarts itself. This command cannot be used while BGP is enabled globally on the switch. Example The following command configures a router to perform graceful BGP restarts only for planned restarts: configure bgp restart planned configure bgp restart address-family configure bgp restart [add | delete] address-family [ipv4-unicast | ipv4-multicast] Description Configures the address family used with graceful BGP restart. Syntax Description add delete ipv4-unicast ipv4-multicast Add the address family. Remove the address family. IPv4 unicast addresses. IPv4 multicast addresses. Default The default is IPv4 unicast. Usage Guidelines This command configures the address family participating in graceful BGP restart. An address family can be added or deleted. By adding an address family, BGP instructs the local hardware and software to preserve BGP routes of that address family during a graceful restart. The local OPEN message contains all the added address families. This command cannot be used while BGP is enabled globally on the switch. Chapter 25. BGP Commands | 1117