Netgear XCM8810 Chassis Hardware Installation Guide - Page 1019
create ospf area, delete ospf area
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1019 highlights
NETGEAR 8800 Chassis Switch CLI Manual • hello interval-Smaller times allow routers to discover each other more quickly, but also increase network traffic. • dead interval-This interval should be a multiple of the hello interval. • wait timer interval-This interval is required by the OSPF standard to be equal to the router dead interval. Under some circumstances, setting the wait interval to smaller values can help OSPF routers on a broadcast network to synchronize more quickly at the expense of possibly electing an incorrect DR or BDR. This value should not be set to less than the hello interval. The default value is equal to the router dead interval. Example The following command configures the OSPF wait interval on the VLAN accounting: configure ospf vlan accounting timer 10 15 20 60 60 create ospf area create ospf area Description Creates an OSPF area. Syntax Description area-identifier Specifies an OSPF area. Default Area 0.0.0.0 Usage Guidelines Area 0.0.0.0 does not need to be created. It exists by default. Example The following command creates an OSPF area: create ospf area 1.2.3.4 delete ospf area delete ospf area [ | all] Description Deletes an OSPF area or all OSPF areas. Chapter 23. OSPF Commands | 1019