Netgear XCM8810 Chassis Hardware Installation Guide - Page 842
con vlan subvlan-address-range
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 842 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Adds or deletes a subVLAN to a superVLAN. Syntax Description vlan_name add delete sub_vlan_name Specifies a superVLAN name. Specifies to add the subVLAN to the superVLAN. Specifies to delete the subVLAN from the superVLAN. Specifies a subVLAN name. Default N/A. Usage Guidelines The following properties apply to VLAN aggregation operation: • All broadcast and unknown traffic remains local to the subVLAN and does not cross the subVLAN boundary. All traffic within the subVLAN is switched by the subVLAN, allowing traffic separation between subVLANs (while using the same default router address among the subVLANs). • Hosts can be located on the superVLAN or on subVLANs. Each host can assume any IP address within the address range of the superVLAN router interface. Hosts on the subVLAN are expected to have the same network mask as the superVLAN and have their default router set to the IP address of the superVLAN. • All IP unicast traffic between subVLANs is routed through the superVLAN. For example, no ICMP redirects are generated for traffic between subVLANs, because the superVLAN is responsible for subVLAN routing. Unicast IP traffic across the subVLANs is facilitated by the automatic addition of an ARP entry (similar to a proxy ARP entry) when a subVLAN is added to a superVLAN. This feature can be disabled for security purposes. Example The following command adds the subVLAN vsub1to the superVLAN vsuper: configure vlan vsuper add subvlan vsub1 configure vlan subvlan-address-range configure vlan subvlan-address-range - Description Configures subVLAN address ranges on each subVLAN to prohibit the entry of IP addresses from hosts outside of the configured range. 842 | Chapter 19. IP Unicast Commands