Netgear XCM8810 Chassis Hardware Installation Guide - Page 167

NETGEAR 8800 Chassis Switch CLI Manual Syntax Description internal-memory old-name-internal new-name-internal memorycard old-name-memorycard new-name-memorycard old-name new-name Specifies the internal memory card. Specifies the current name of the core dump file located on the internal memory card. Specifies the new name of the core dump file located on the internal memory card. Specifies the removable external compact flash card. Specifies the current name of the file located on the external compact flash memory card. Depending on your switch configuration, you can have configuration, policy, or cord dump files stored in this card. Specifies the new name of the file located on the external compact flash memory card. Specifies the current name of the configuration or policy file on the system. Specifies the new name of the configuration or policy file on the system. Default N/A. Usage Guidelines When you rename a file with a given extension, remember the following: • XML-formatted configuration files have the .cfg file extension. The switch only runs .cfg files. • ASCII-formatted configuration files have the .xsf file extensions. See Appendix B in the NETGEAR 8800 User Manual for more information. • Policy files have the .pol file extension. • Core dump files have the .gz file extension. See Internal Memory and Core Dump Files on page 168 for more information. Make sure the renamed file uses the same file extension as the original file. If you change the file extensions, the file may be unrecognized by the system. For example, if you have an existing configuration file named test.cfg, the new filename must include the .cfg file extension. You cannot rename an active configuration file (the configuration currently selected to boot the switch). To verify the configuration that you are currently using, issue the show switch {detail} command. If you attempt to rename the active configuration file, the switch displays a message similar to the following: Error: Cannot rename current selected active configuration file. When you rename a file, the switch displays a message similar to the following: Rename config test.cfg to config megtest.cfg on switch? (y/n) Chapter 4. Commands for Managing the NETGEAR 8800 Software | 167