Netgear XCM8810 Chassis Hardware Installation Guide - Page 309
disable inline-power ports
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 309 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default Disable. Usage Guidelines This command disables the non-standard power-detection mechanism on the switch or specified slot. Legacy PDs do not conform to the IEEE 802.3af standard but may be detected by the switch through a capacitance measurement. However, measuring the power through capacitance is used only if this parameter is enabled and after an unsuccessful attempt to discover the PD using the standard resistance measurement method. The default for legacy is disabled. The reason legacy detection is configurable is that it is possible for a normal (non-PoE) device to have a capacitance signature that causes the device to be detected as a legacy PoE device and have power delivered to it, potentially causing damage to the device. On a stack if you do not specify a slot number, the command operates on all active nodes. This command operates only on nodes in the active topology. Example The following command disables capacitance detection of PDs on slot 3 of the NETGEAR 8800: disable inline-power legacy slot 3 disable inline-power ports disable inline-power ports [all | ] Description Shuts down PoE power currently provided to all ports or to specified ports. Syntax Description all port_list Disables inline power to all ports on the switch. Disables inline power to the specified ports. Default Enable. Usage Guidelines Disabling inline power to ports immediately removes power to any connected PDs. By default, the capability to provide inline power to all ports is enabled. Chapter 7. PoE Commands | 309