Netgear XCM8810 Chassis Hardware Installation Guide - Page 340
con log filter events match, to the standby nodes.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 340 highlights
NETGEAR 8800 Chassis Switch CLI Manual configure log filter myStpFilter add exclude events stp.inbpdu.drop configure log filter events match configure log filter [add | delete] {exclude} events [ | [all | ] {severity {only}}] [match | strict-match] Description Configures a log filter to add or delete detailed feature messages based on a specified set of events and match parameter values. In a stack, this command is applicable only to Master and Backup nodes and not applicable to the standby nodes. Syntax Description name add delete exclude event-condition all event-component severity only match strict-match type value Specifies the filter to configure. Add the specified events to the filter. Remove the specified events from the filter. Events matching the filter will be excluded. Specifies the event condition. Specifies all events. Specifies all the events associated with a particular component. Specifies the minimum severity level of events (if the keyword only is omitted). Specifies only events of the specified severity level. Specifies events whose parameter values match the pair. Specifies events whose parameter values match the pair, and possess all the parameters specified. Specifies the type of parameter to match. For more information about types and values see Types and Values on page 341. Specifies the value of the parameter to match. For more information about types and values see Types and Values on page 341. Default If the exclude keyword is not used, the events will be included by the filter. If severity is not specified, then the filter will use the component default severity threshold (see the note on page 338 when delete or exclude is specified). 340 | Chapter 8. Commands for Status Monitoring and Statistics