Netgear XCM8810 Chassis Hardware Installation Guide - Page 1062
enable ospfv3, enable ospfv3 export, adjacencies, link state advertisements, run-time memory, etc.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1062 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines Use this command to stop OSPFv3 from exporting routes derived from other protocols. Example The following command disables OSPFv3 to export RIPng routes to other OSPFv3 routers: disable ospfv3 export ripng enable ospfv3 enable ospfv3 {domain } Description Enables OSPFv3 for the router. Syntax Description domainName Specifies an OSPFv3 domain. OSPF-Default is the only one currently supported. Default N/A. Usage Guidelines When OSPFv3 is enabled, it will start exchanging Hellos on all of it's active interfaces. It will also start exporting routes into OSPFv3 routing domain from other protocols, if enabled. When OSPFv3 is disabled, it will release all the run-time allocated resources like adjacencies, link state advertisements, run-time memory, etc. OSPFv3 can be enabled successfully if and only if: • At least one of the VLANs in the current virtual router has one IPv4 address configured -OR- • You explicitly configure the OSPFv3 router ID, a four-byte, dotted decimal number Example The following command enables OSPFv3 for the router: enable ospfv3 enable ospfv3 export enable ospfv3 {domain } export [direct | ripng | static] [cost type [ase-type-1 | ase-type-2] | ] 1062 | Chapter 24. OSPFv3 Commands