Netgear XCM8810 Chassis Hardware Installation Guide - Page 115
Example, CLI scripting settings
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
NETGEAR 8800 Chassis Switch CLI Manual • SNMP community strings • SNMP trap receiver list • SNMP trap receiver source IP address • SNMP statistics counter • SSH access states of enabled, disabled, and module not loaded • CLI configuration logging • SNMP access states of v1, v2c disabled and v3 enabled If all three types of SNMP access are enabled or disabled, SNMP access is displayed as either Enabled or Disabled. • Enable/disable state for RMON • Access-profile usage configured via Access Control Lists (ACLs) for additional Telnet and SSH2 security • CLI scripting settings • Enable/disable state • Error message setting • Persistence mode • Dropped SNMP packet counter. Example The following command displays configured SNMP settings on an 8800 switch: show management The following is sample output from this command: CLI idle timeout : Enabled (20 minutes) CLI max number of login attempts : 3 CLI max number of sessions : 8 CLI paging : Enabled (this session only) CLI space-completion : Disabled (this session only) CLI configuration logging : Disabled CLI scripting : Disabled (this session only) CLI scripting error mode : Ignore-Error (this session only) CLI persistent mode : Persistent (this session only) Telnet access : Enabled (tcp port 23 vr all) : Access Profile : not set SSH Access : ssh module not loaded. Web access : Disabled (tcp port 80) Total Read Only Communities : 1 Total Read Write Communities : 1 RMON : Disabled SNMP access : Enabled : Access Profile Name : not set SNMP Traps : Enabled Chapter 3. Commands for Managing the Switch | 115