Netgear XCM8810 Chassis Hardware Installation Guide - Page 1235
The following command displays the detailed PIM configuration and statistics
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1235 highlights
NETGEAR 8800 Chassis Switch CLI Manual Legend: J/P Int: Join/Prune Interval Flags : r - Router PIM Enabled, i - Interface PIM Enabled, f - Interface, Forwarding Enabled, m - Interface Multicast Forwarding Enabled, s - Sparse mode, d - Dense mode, c - CRP enabled, t - Trusted Gateway configured, n - Multinetted VLAN, p - Passive Mode, S - Source Specific Multicast, b - Border, R - State Refresh Enabled. The following command displays the detailed PIM configuration and statistics: Switch.22 # show pim detail PIM Enabled, Version 2 PIM CRP Disabled BSR state : ACCEPT_ANY ; BSR Hash Mask Length: 255.255.255.252 Current BSR Info : 0.0.0.0 (Priority 0) Configured BSR Info : 0.0.0.0 (Priority 0) CRP Adv Interval : 60 sec ; CRP Holdtime: 150 BSR Interval : 60 sec ; BSR Timeout : 130 Cache Timer : 210 sec ; Prune Timer : 210 Assert Timeout : 210 sec ; Register Suppression Timeout,Probe: 60, 5 Generation Id : 0x4a01a1a6 PIM-DM State Refresh Source Active Timer : 210 sec PIM-DM State Refresh TTL : 16 PIM-DM State Refresh Origination Interval: 60 sec Threshold for Last Hop Routers: 0 kbps Threshold for RP : 0 kbps Register-Rate-Limit-Interval : Always active PIM SSM address range : None Register Checksum to include data Active Sparse Ckts 0 Dense Ckts 1 Global Packet Statistics (In/Out) C-RP-Advs 0 0 Registers 0 0 RegisterStops 0 0 PIM DENSE Interface[2] on VLAN v36 is enabled and up IP adr: 36.36.36.3 mask: 255.255.0.0 DR of the net: 36.36.36.6 Passive : No Hello Interval : 30 sec Neighbor Time out : 105 sec Join/Prune Interval : 60 sec Join/Prune holdtime : 210 sec Trusted Gateway : none CRP group List : none with priority 0 Shutdown priority : 1024 Chapter 26. IP Multicast Commands | 1235