Netgear XCM8810 Chassis Hardware Installation Guide - Page 866
enable iparp checking, enable iparp refresh, If you do not specify a virtual router
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 866 highlights
NETGEAR 8800 Chassis Switch CLI Manual redirect message to the originating router. If ICMP useredirects is enabled, the switch adds a route to the destination network using the third router as the next hop and starts sending the packets to the third router. Example The following command enables the modification of route table information: enable icmp useredirects enable iparp checking enable iparp {vr } checking Description Enables checking if the ARP request source IP address is within the range of the local interface or VLAN domain. Syntax Description vr_name Specifies a virtual router. Default Enabled. Usage Guidelines If you do not specify a virtual router, the command applies to the current virtual router. Example The following command enables IP ARP checking: enable iparp checking enable iparp refresh enable iparp {vr } refresh Description Enables IP ARP to refresh its IP ARP entries before timing out. Syntax Description vr_name Specifies a virtual router. 866 | Chapter 19. IP Unicast Commands