Netgear XCM8810 Chassis Hardware Installation Guide - Page 343
More Information, Example, Description, Syntax Description, con log target filter
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 343 highlights
NETGEAR 8800 Chassis Switch CLI Manual MAC address. If you specify the strict-match keyword, then the filter will never match, since XYZ.event5 does not contain the destination MAC address. In other words, if the match keyword is specified, an incident will pass a filter so long as all parameter values in the incident match those in the match criteria, but all parameter types in the match criteria need not be present in the event definition. More Information See the command show log on page 387 for more information about severity levels. To get a listing of the components present in the system, use the following command: show log components To get a listing of event condition definitions, use the following command: show log events To see the current configuration of a filter, use the following command: show log configuration filter {} Example By default, all log targets are associated with the built-in filter, DefaultFilter. Therefore, the most straightforward way to send additional messages to a log target is to modify DefaultFilter. In the following example, the command modifies the built-in filter to allow incidents in the STP component, and all subcomponents of STP, of severity critical, error, warning, notice and info. For any of these events containing a physical port number as a match parameter, limit the incidents to only those occurring on physical ports 3, 4 and 5 on slot 1, and all ports on slot 2: configure log filter DefaultFilter add events stp severity info match ports 1:3-1:5, 2:* If desired, issue the unconfigure log DefaultFilter command to restore the DefaultFilter back to its original configuration. configure log target filter configure log target [console | memory-buffer | primary-msm | primary-node | backup-msm | backup-node | nvram | session | syslog [all | | {vr } [local0 ... local7]]] filter {severity {only}} Description Associates a filter to a target. In a stack, this command is applicable only to Master and Backup nodes. This command is not applicable to standby nodes. Syntax Description target Specifies the device to send the log entries. Chapter 8. Commands for Status Monitoring and Statistics | 343