Netgear XCM8810 Chassis Hardware Installation Guide - Page 221
disable slot, Power Off/Disabled.
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command disables sharing on master logical port 9 in slot 3, which contains ports 9 through 12: disable sharing 3:9 disable slot disable slot {offline} Description Disables slot and leaves that module in a power down state. Syntax Description slot offline Specifies the slot to be disabled. Specifies that the slot be disabled offline. Note: This variable is supported only on the NETGEAR 8800 series switches; that is, those switches that support offline diagnostics. Default Enabled. Usage Guidelines This command allows the user to disable a slot. When the user types this command, the I/O card in that particular slot number is brought down, and the slot is powered down. The LEDs on the card go OFF. A disabled slot can be re-enabled using the enable slot command. When the slot is re-enabled, the software on the I/O module is updated to match the software on the primary MSM/MM. The show slot command, if invoked after the user disables the slot, shows this slot state as "Power Off/Disabled." If there is no I/O card present in a slot when the user disables the slot, the slot still goes to the "Disable" state. If a card is inserted in a slot that has been disabled, the card does not come up and stays in the "Power Off/Disabled" state until the slot is enabled by using the enable slot command. below. If you do not save the configuration before you do a switch reboot, the slot will be re-enabled upon reboot. If you save the configuration after disabling a slot, the slot will remain disabled after a reboot. On Power over Ethernet (PoE) modules, disabling a slot also disables any inline power that in flowing to that slot. Chapter 5. Commands for Configuring Slots and Ports on a Switch | 221