Netgear XCM8810 Chassis Hardware Installation Guide - Page 1183
con mvr add receiver, By default
View all Netgear XCM8810 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1183 highlights
NETGEAR 8800 Chassis Switch CLI Manual unicast unicast-only vrname Specifies a unicast route to delete. Specifies a unicast route to delete. Specifies the virtual router to which the route is deleted. Default If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines Use a value of 255.255.255.255 or /32 for mask to indicate a host entry. Example The following command deletes an address from the multicast routing table: configure iproute delete 10.101.0.0/24 10.101.0.1 multicast configure mvr add receiver configure mvr vlan add receiver port Description Configures a port to receive MVR multicast streams. Syntax Description vlan-name port-list Specifies a VLAN name. A list of ports or slots and ports. Default N/A. Usage Guidelines This command is used to add a group of virtual ports for multicast forwarding through MVR. By default, some ports on non-MVR VLANs (router ports) are excluded from the MVR cache egress list. This command is used to override these rules, so that if valid IGMP memberships are received, or a router is detected, streams are forwarded out on the ports. Example The following command adds the ports 1:1 and 1:2 of VLAN v1 to MVR for forwarding: configure mvr vlan v1 add receiver port 1:1-1:2 Chapter 26. IP Multicast Commands | 1183