Netgear GS418TPP User Manual - Page 104

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select System> Services > DHCP Snooping > Global Configuration. 6. Select the DHCP Snooping Mode Enable radio button. 7. To enable the verification of the sender's MAC address for DHCP snooping, select the MAC Address Validation Enable radio button. When MAC address validation is enabled, the device checks packets that are received on an untrusted interface to verify that the MAC address and the DHCP client hardware address match. If the addresses do not match, the device drops the packet. 8. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. Enable DHCP for All Interfaces in a VLAN  To enable DHCP snooping for all interfaces that are members of a VLAN: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. Configure System Information 104