Netgear GS418TPP User Manual - Page 79

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP • 4pt 802.3af + Legacy. The port performs a 4-point resistive detection, and if required, continues with legacy detection. • Legacy. The port performs legacy detection. 13. From the Timer Schedule menu, select a timer schedule or select None, which is the default selection. For information about setting up and configuring PoE timer schedules, see Set Up PoE Timer Schedules on page 118. 14. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. The following table describes the nonconfigurable fields on the page. Table 25. PoE Port Configuration Field High Power Max Power (mW) Class Output Voltage (Volts) Output Current (mA) Output Power (W) Status Description All ports supports high power mode. The maximum power in milliwatts that can be provided by the port. The class defines the range of power that a powered device (PD) is drawing from the switch. The class definitions are as follows: • 0: 0.44-16.2W • 1: 0.44-4.2W • 2: 0.44-7.4W • 3: 0.44-16.2W • 4: 0.44-31.6W • Unknown. The class cannot be detected, or no PD is attached to the port. The voltage that is delivered to the PD in volts. The current that is delivered to the PD in mA. The power that is delivered to the PD in watts. The operational status of the port. The possible values are as follows: • Disabled. No power is delivered. • Delivering Power. Power is being drawn by the PD. • Requesting Power. The port is requesting power. • Fault. A problem occurred with the power. • Test. The port is in test mode. • Other Fault. The port is idle because of an error condition. • Searching. The port is not in one of the other states in this list. Configure System Information 79