Netgear GS418TPP User Manual - Page 306

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP Configure Access Rule Settings You can add security access rules. You can apply changes to an access rule only when the access profile is in a deactivated state. Note: Make sure that the access profile is created before adding the rules.  To configure the access rule settings: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Security > Access > Access Control > Access Rule Configuration. 6. From the Rule Type menu, select Permit or Deny to permit or deny access when the selected rules are matched. A Permit rule allows access by traffic that matches the rule criteria. A Deny rule blocks traffic that matches the rule criteria. 7. From the Service Type menu, select the access method to which the rule is applied. The policy is restricted by the selected access method. Possible access methods are HTTP, Secure HTTP (SSL), and SNMP. 8. In the Source IP Address field, enter the source IP address of the client originating the management traffic. 9. In the Mask field, specify the subnet mask of the client that originates the management traffic. Manage Device Security 306