Netgear GS418TPP User Manual - Page 181

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP 6. To enable IGMP snooping on a VLAN, in the VLAN ID field, enter the VLAN ID. 7. Configure the IGMP snooping values: • Admin Mode. Enable or disable IGMP snooping for the specified VLAN ID. The default is Disable. • Fast Leave Mode. Enable or disable the IGMP snooping fast leave mode for the specified VLAN ID. The default is Disable. • Host Timeout. Set the value for group membership interval of IGMP snooping for the specified VLAN ID. The valid range is Maximum Response Time + 1 to 3600 seconds. • Maximum Response Time. Set the value for the maximum response time of IGMP snooping for the specified VLAN ID. The valid range is 1 to Group Membership Interval -1. This value must be greater than group membership interval value. • MRouter Timeout. Set the value for multicast router expiry time of IGMP snooping for the specified VLAN ID. The valid range is 0 to 3600 seconds. • Report Suppression Mode. Enable or disable IGMP snooping report suppression mode for the specified VLAN ID. IGMP snooping report suppression allows the suppression of the IGMP reports sent by the multicast hosts by building a Layer 3 membership table. The results is that only the most essential reports are sent to the IGMP routers so that the routers can continue to receive the multicast traffic.The default is Disable. • Querier Mode. Enable or disable the IGMP querier mode. If proxy querier mode is disabled, then an IGMP proxy query with source IP 0.0.0.0 is not sent in response to an IGMP leave packet. The default is Disable. • Query Interval. Set the IGMP query interval for the specified VLAN ID. The valid range is 1 to 1800 seconds. The default is 60 seconds. 8. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. Configure Switching 181