Netgear GS418TPP User Manual - Page 217
Con IPv6, Con IPv6 Global Settings
View all Netgear GS418TPP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP Configure IPv6 Note: IPv6 is supported on VLAN interfaces only, not on physical ports. Configure IPv6 Global Settings You can configure IPv6 routing parameters for the switch, as opposed to for an interface. To configure IPv6 global settings: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Routing> IPv6 > Basic > Global Configuration. 6. Next to IPv6 Unicast Routing, specify whether IPv6 unicast routing is globally enabled by selecting the Enable radio button or the Disable radio button. 7. In the Hop Limit field, enter a value for the unicast hop count used in IPv6 packets originated by the node. The value is also included in router advertisements. The valid values for hops are 1 to 255, inclusive. The default is Not Configured, which means that a value of zero is sent in router advertisements. 8. In the ICMPv6 Rate Limit Error Interval field, specify the number of ICMP error packets allowed per burst interval. Configure Routing 217