Netgear GS418TPP User Manual - Page 150

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP Configure GARP Ports Note: It can take up to 10 seconds for the GARP configuration changes to take effect.  To configure GARP ports: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Switching> VLAN > Advanced > GARP Port Configuration. 6. Select one or more interfaces by taking one of the following actions: • To configure a single interface, select the check box associated with the port, or type the port number in the Go To Interface field and click the Go button. • To configure multiple interfaces with the same settings, select the check box associated with each interface. • To configure all interfaces with the same settings, select the check box in the heading row. 7. From the GVRP Mode menu, select Enable or Disable. This specifies the GARP VLAN registration protocol administrative mode for the port. If you select Disable, the protocol is not active and the join time, leave time, and leave all time options are without any effect. The default is Disable. Configure Switching 150