Netgear GS418TPP User Manual - Page 75

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP 8. In the Max Samples to keep field, enter the maximum number of samples to keep. This is a global setting and is applied to all interfaces. The range is 1 to 168.The default value is 168. 9. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. The Percentage LPI time field shows the time spent in LPI mode the since EEE counters were last cleared. The following table describes the nonconfigurable fields. Table 23. Interface Green Mode EEE LPI History information Field Sample No. Time Since The Sample Was Recorded Percentage Time spent in LPI mode since last sample Percentage Time spent in LPI mode since last reset Description Sample index. Each time the page is refreshed, it shows a different time as it reflects the difference between current time and time at which the sample was recorded. Percentage of time spent in LPI mode during the current measurement interval. Percentage of time spent in LPI mode since EEE LPI statistics were reset. Use the Device View For information about the device view, see Web Browser-Based Management Interface Device View on page 21. Configure PoE You can configure the global Power over Ethernet (PoE) configuration settings and the PoE settings for each port. Configure the Global PoE Settings  To configure the PoE settings: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. Configure System Information 75