Netgear GS418TPP User Manual - Page 421

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP Traceroute IPv4 You can configure the switch to send a traceroute request to a specified IP address or host name. You can use this to discover the paths that packets take to a remote destination. Once you click the Apply button, the switch sends a traceroute and the results are displayed below the configurable data. If a reply to the traceroute is received, the following message displays: 1 e.f.g.h 9869 usec 9775 usec 10584 usec 2 0.0.0.0 0 usec * 0 usec * 0 usec * 3 0.0.0.0 0 usec * 0 usec * 0 usec * Hop Count = j Last TTL = k Test attempt = m Test Success = n.  To send an IPv4 traceroute: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Maintenance > Troubleshooting > Traceroute IPv4. Maintenance 421