Netgear GS418TPP User Manual - Page 364

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP You can either enter the port range yourself or select one of the following protocols from the menu: • The source IP TCP port protocols are domain, echo, ftp, ftpdata, www-http, smtp, telnet, pop2, pop3, and bgp. • The source IP UDP port protocols are domain, echo, snmp, ntp, rip, time, who, and tftp. Each of these values translates into its equivalent port number, which is used as both the start and end of the port range. Select Other from the menu to enter port numbers. If you select Other from the menu but leave the fields blank, it means any. • Dst. In the Dst field, enter a destination IPv6 address to be compared to a packet's destination IPv6 address as a match criterion for the selected IPv6 ACL rule: - If you select the IPv6 Address radio button, enter an IPv6 address to apply this criteria. If this field is left empty, it means any. - If you select the Host radio button, enter a host source IPv6 address to match the specified IPv6 address. If this field is left empty, it means any. The source IPv6 address argument must be in the form documented in RFC 2373 where the address is specified in hexadecimal numbers using 16-bit values between colons. • Dst L4. The options are available only when the protocol is set to TCP or UDP. Use the destination L4 port option to specify relevant matching conditions for L4 port numbers in the extended ACL rule. You can select either the Port radio button or the Range radio button: - If you select the Port radio button, you can either enter the port number yourself or select one of the following protocols from the menu: • The destination IP TCP port protocols are domain, echo, ftp, ftpdata, www-http, smtp, telnet, pop2, pop3, and bgp. • The destination IP UDP port protocols are domain, echo, snmp, ntp, rip, time, who, and tftp. Each of these values translates into its equivalent port number, which is used as both the start and end of the port range. Select Other from the menu to enter a port number. If you select Other from the menu but leave the field blank, it means any. The relevant matching conditions for L4 port numbers are as follows: • Equal. The IPv6 ACL rule matches only if the Layer 4 destination port number is equal to the specified port number or port protocol. • Less Than. The IPv6 ACL rule matches if the Layer 4 destination port number is less than the specified port number. Manage Device Security 364