Netgear GS418TPP User Manual - Page 76

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select System > PoE > Basic > PoE Configuration. 6. In the System Usage Threshold field, enter a number from 1 to 99 to set the threshold level at which a trap is sent if the consumed power exceeds the threshold power. 7. From the Power Management mode menu, select the power management algorithm that the switch uses to deliver power to the requesting powered devices (PDs): • Static. Specifies that the power allocated for each port depends on the type of power threshold configured on the port. • Dynamic. Specifies that the power consumption on each port is measured and calculated in real time. 8. To active the PoE traps, from the Traps menu, select Enable. Selecting Disable deactivates the PoE traps. The default setting is Enabled. 9. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. The following table describes the nonconfigurable fields on the page. Table 24. PoE Configuration fields Field Description Firmware Version The firmware version of the PoE firmware component. Power Status The power status. Total Power Available Watts The maximum amount of power in watts that the switch can deliver to all ports. Configure System Information 76