Netgear GS418TPP User Manual - Page 246

ProSAFE 8-Port or 16-Port Gigabit Smart Managed Switch Model GS418TPP, GS510TLP, and GS510TPP View or Globally Configure the ARP Table You can change the configuration parameters for the Address Resolution Protocol (ARP) table. You can also use this page to display the contents of the table.  To configure the ARP table: 1. Connect your computer to the same network as the switch. You can use a WiFi or wired connection to connect your computer to the network, or connect directly to a switch that is off-network using an Ethernet cable. 2. Launch a web browser. 3. In the address field of your web browser, enter the IP address of the switch. If you do not know the IP address of the switch, see Change the Default IP Address of the Switch on page 11. The login window opens. 4. Enter the switch's password in the Password field. The default password is password. The System Information page displays. 5. Select Routing> ARP > Advanced > Global ARP Configuration. 6. In the Age Time field, enter the time, in seconds, that a dynamic ARP entry remains in the ARP table before aging out. The range is 15 to 21600 seconds. The default value is 1200 seconds. 7. In the Response Time field, enter the time, in seconds, that the device waits for an ARP response to an ARP request that it sends. The range for this field is 1 to 10 seconds. The default value is 1 second. 8. In the Retries field, enter the maximum number of times an ARP request is retried after an ARP response is not received. The number includes the initial ARP request. The range for this field is 0 to 10. The default value is 4. 9. In the Cache Size field, specify the maximum number of entries allowed in the ARP table. This number includes all static and dynamic ARP entries.The range for this field is 79 to 738. The default value is 738. Configure Routing 246